The last stage of my Harman tour took Sean E. Olive, Director of Acoustic Research, and I to areas that contain a few anechoic chambers. You may have seen one of these specially designed, super quiet rooms in an audio textbook but until you’ve had a chance to actually spend a few minutes in one, you can’t really understand how really creepy it can be. My first experience with an anechoic chamber was at UCLA many years ago…and I can recall hearing my heartbeat and nervous system after settling down in the room with the door closed. The ones at Harman are used to measure and test speaker response, diffusion patterns and overall performance of different drivers. We didn’t spend much time inside.<\/p>\n
There was one particular chamber that had an array of calibration microphones uniformly spaced along the perimeter of a vertically oriented quarter circle. Dr. Olive explained that this particular setup was used to test how much off axis sound comes from a speaker. The best performance can be found by listening to a speaker from right in front of it (German Physiks omni directional designs not withstanding). What happens to the sound as you move away from the front is also tremendously important because that sound will also be bouncing around the room and may not contain the optimal blend of the entire frequency response.<\/p>\n
Our final stop was in a room housing a stereo pair of M2 Master Reference Monitors. I’ve spoken of these amazing speakers in a previous post (click here<\/a> to read the post) and I did get the chance to audition them at last year’s Rocky Mountain Audio Fest. I was impressed and very interested because of the new drivers that JBL developed to extend the accuracy of ultrasonic and low frequency playback. I actually met the engineer that developed the D2 dual-diaphragm dual voice-coil high-frequency compression driver at the Newport show. He was pretty proud of his accomplishment and he should be.<\/p>\n Dr. Olive handed me one of the drivers and it must have weighed 15 pounds, yet it fit in the palm of my hand. I also checked out the unique construction of the 2216Nd Differential Drive low-frequency transducer…another real marvel of engineering. The third piece of the M2 is the “Image Control waveguide” double axis horn (see figure below).<\/p>\n
![\"140512_M2_horn\"](\"http:\/\/www.realhd-audio.com\/wp-content\/uploads\/2014\/05\/140512_M2_horn.jpg\")
<\/a><\/p>\n